3d print your own Star Destroyer

Discussion in 'General Modeling' started by xeno, May 5, 2015.

  1. xeno

    xeno Well-Known Member

    Trophy Points:
    746
    32buds likes this.
  2. myc

    myc Active Member

    Trophy Points:
    341
    wow ... that is crazy
     
  3. mythshaker

    mythshaker Active Member

    Trophy Points:
    242
    Well, I successfully imported it into both Meshlab and Turbocad. But deconstructing it down to printable pieces would be hella lot of work.
     
  4. stonky

    stonky Sr Member RPF PREMIUM MEMBER

    Trophy Points:
    1,390
    Looks like it might be the infamous fractalsponge build which was made available for download years ago and has turned up everywhere as a result (including a Force Unleashed trailer).
     
  5. steve_jones

    steve_jones Active Member

    Trophy Points:
    261
    You could break down the detailed parts where the greebles are , so the brim trenches super structure detail and shuttle bays etc.. ( speaking from experience from scratch building them all ) doing it and then make your own structure and attaching

    Star destroyer in a box ( almost)
     

Share This Page