-
-
xeno replied to the thread What’s on Your Workbench? (Star Wars items only).If you are going for the Studio scale likeness, then a rod up the backside is ok, as the ILM model also has it. I will use a very sturdy... -
Added more detail to the engine , also started the connectors between the engine and the legs……
-
xeno replied to the thread What’s on Your Workbench? (Star Wars items only).Working on the Studio scale ROTJ AT-ST. but I realized it is too big, so I have to start over :/
-
-
xeno replied to the thread Urethane Casting Questions.There are a lot of people here with a lot of experience And search Youtube (y)
-
xeno replied to the thread Urethane Casting Questions.You might want to look at Smooth-On the have loads of information, and video's. not saying it is the best, but information will get you...
-
xeno replied to the thread Urethane Casting Questions.#1 - Urethane rubber doesn't dry out like latex, but still depends on the quality of the urethane, you will know after a few years. #2 -...
-
After a few weeks off ,a small bit of progress..
-
xeno reacted to laellee's post in the thread !/24th Scale Police Spinner (Fujimi) with Lights with
Like.
Love seeing someone using a 555! I see a lot of people bringing arduinos and other overpowered microprocessors into projects that a 555... -
xeno reacted to gerald14's post in the thread !/24th Scale Police Spinner (Fujimi) with Lights with Like.
Hello, I made this assembly which allows to obtain a fairly progressive flashing. You can use 5mm, 3mm and SMD LEDs. For my part, I use...
-
xeno replied to the thread !/24th Scale Police Spinner (Fujimi) with Lights.I would love to hear more about the lights.
-
xeno replied to the thread Neverending nepotism in Hollywood?.Hollywood is just very visible, and you can look up names and family, and just because it is a profession, that potentially brings in...
-
Ah ok ill mess with that and see how it goes, and yeah haha we were still messing with print angles and layer height when I did the...
-
Lots of little parts added and the first coat of primer….the back , gun and underside are all held on with magnets
-
xeno replied to the thread 1/38 Alain Rivard 3D Printed Y-Wing.It may be because your exposure time is too high. also when printing these kinds of open, thin walled shapes, they get distorted due to...
-
-
Side bits glued on…legs next…..
-
-
Loading…
-
Loading…
everything Sci Fi and Science
- Website
- http://www.xenoweb.nl