1/24 Rogue One TIE SRIKER build

BorgHive

BorgHive

New Member
This is going to be my build thread for this huge 1/24 scale TIE Striker resin kit which when the wing guns get mounted will be over 28 inches long. Using the clear red cockpit sidewalls I'll be lighting up the cockpit and rear engines. This model is in scale with all 1/24 star wars fighters
 

Attachments

  • 03.jpg
    03.jpg
    98.7 KB · Views: 236
Parts not glued or anything, just held in place for photos. A lot more details go on these parts This is just to give you an idea some of the main parts. Details and guns not attached, nothing is attached.
 

Attachments

  • 7.jpg
    7.jpg
    86.3 KB · Views: 275
  • 8.jpg
    8.jpg
    74 KB · Views: 268
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

E=MC2
1/48 scale star wars tie bomber in the making.
Replies
4
Views
276
E=MC2
E=MC2
Antsnest
AMT 1/32 TIE Build
Replies
16
Views
1,989
Boxcar Bret
Boxcar Bret
skahtul
3D Printed (Saturn 12K Ultra) 1/24 Scale TIE and X-Wing **WIP**
2
Replies
35
Views
3,734
skahtul
skahtul
gboy1801
Tie X-1 from MPC
Replies
6
Views
1,070
DJSLY
DJSLY
StevenBills
1:24 X-Wing Red 3 **WIP**
3 4 5
Replies
95
Views
7,163
StevenBills
StevenBills
Back
Top