How did you get the curved acrylic hull? Loops amazing!!
Treadwell is right maxhebus! The rough contour is figured out, laser cut out of acrylic (for the walkways at least), then I use a combination of a belt sander and dremel to get the contour closer, then fine tune with varying grits of sandpaper. It's very much raw fabricating in order to get a flush fit. Particularly with making the bevel, all hand ground and sanded. Same goes with the cockpit tube, but with that fella, I cut a paper template, draw an outline on the tube, rough cut with a dremel, then fine tune again with dremel drum and then sandpaper. This is truly 'old school' hand labor, but the results are quite nice.
Joberg and other folks, thank you again for the kind comments!!
I'm off for a business trip this week, but will get some updates next weekend. I plan to have the engine deck bonded together then.
Thanks,
Sean