So, here's where I stand today.
The Grenade rim sleeve.
It's just regular old sink pipe, and it only extends to the first cut out. Very, very rock solid now.
Of which, I'll have to either cut down the screws I used for Roman's transistors/spacer and put a nut in there, or just glue them on. Not sure yet. Any ideas guys?
I installed a Left-over D ring from Blast Tech. It was a bit smaller than Roy's, and I mean a hair smaller, but it suffices
(Thank you @
RomansEmpire for the D ring installation tips)
Notice, I used cheap painters tape to keep the clear coat off the pommel and it took up a few pieces of new chrome! Grr, be careful guys)
I'm thinking I may hit the emitter and cone with some clear coat too...The emitter's gotten darker over the years and now there's rust forming on the cone?!
Anyways, here it is before the transistors!