That's a good way to estimate the size too. Those are clear parts from the V8 kit right?Here's a shot of a few of the vents inside one of the original R3 domes.
They're very shiny and clear.
Correct. That is the cylinder head cap (part number 18) from the V8 kit.That's a good way to estimate the size too. Those are clear parts from the V8 kit right?
What do you think of this for the top knob? This is from the Michell turn table. I'd be happy to do a machined aluminum run of these if there's enough interest. The inside of this knob is threaded - Would it need to be threaded or solid?
View attachment 1443991
View attachment 1443992
Speak up and let me know, thanks! - Chad
That's the same piece.Is this the same knob posted by lonepigeon earlier on? The knurling/finish/top chamfering seem a hair different? Could just be lighting, though.
Is this part from the turntable sweep arm?What do you think of this for the top knob? This is from the Michell turn table. I'd be happy to do a machined aluminum run of these if there's enough interest. The inside of this knob is threaded - Would it need to be threaded or solid?
View attachment 1443991
View attachment 1443992
Speak up and let me know, thanks! - Chad
Is this part from the turntable sweep arm?
I found some better reference of the red/orange piece that replaces the Sparklets cap.
It's also used on the medical droid FX-7.
(I left the V-8 parts and TC-67 tape corder button in there for scale)
View attachment 1445398
Are you saying this knob is the red knob on the Sparklets top where the flip cap and such are removed?I found some better reference of the red/orange piece that replaces the Sparklets cap.
It's also used on the medical droid FX-7.
(I left the V-8 parts and TC-67 tape corder button in there for scale)
View attachment 1445398