pretzel399
Active Member
Well, I'm very unfamiliar with casting with the metal powder but is it the amount of time it takes for the resin to cure that lets the metal sink to the bottom? Would if be possible to use a different resin with a shorter cure time?
Also, what if you made the ingots just a little thicker and we could sand off the bottom of them where the line shows?
These are just thoughts, and probably not good ones. Personally I don't mind the thin line of flashing if nothing can be done about it. So sorry you're having so much trouble.
Also, what if you made the ingots just a little thicker and we could sand off the bottom of them where the line shows?
These are just thoughts, and probably not good ones. Personally I don't mind the thin line of flashing if nothing can be done about it. So sorry you're having so much trouble.