Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


TheCopperhead

New Member
Almost finished this 1/6 scale stop motion Cyclops puppet for a personal short film project. Fully articulated with a ball and socket armature (from Malvern Armatures) and cast in expanding polyurethane foam with an outer latex skin from a sculpture moulded in plaster. Details like the horns and fingers/toes were sculpted in Milliput. Final costume still needs looking at, as does the prop spear. I'm currently working on replacing the wrist sections with a ball joint, as the wire isn't holding up as well as I hoped.
Anyway just thought I'd share with everyone on here!
EDITCYCLOPSPUPPETAL2019.jpg
IMG_4905 copy.jpg
58374686_977920935746696_2844679233823834112_o.jpg
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top