I obtained an EP3 obi stunt from the saber tech

[Bowelrock]

Ahhh youve been ZAPPED....... :confused :confused


I built this using stuff from my local ace hardware.. IT holds a 3/8th fiberglass rod that just wont break. THe hole thinkg weighs about 2 lbs. LMK what you think.. I can get you part numbers so you can build your own The emitter is a Parks.
All I need is a resin pommel to finish it off.

 

[DarthJRW]

man.......now thats is kool....


pm sent bout the parts

 

[Primrodo]

Looks great. Look forward to a tutorial.

But curious...why using 3/8" as opposed to the correct 1/2"?

 

[DavidS]

is that the anakin stunt that i sold to you?

 

[Crimsonnaire]

Outstanding work.

Was the emitter section for the Anakin ROTS purchased from the hardware store as well? I've always found it interesting as to why the section below the emitter on the Anakin stunt is thinner. Could it be to improve twirling?

Are the blades sturdy enough to duel with?

 

[Bowelrock]

The anakin was machined not made although I could make one using the same process.,. I bought it from sporak Thanks bill :") THe 3/8ths rods are realy cheap and thats All I have realy been using.. If I can find 1/2 for $2.00 a piece like these then I will buy them

Imperious825
THE ani was machined and yes the blades are realy sturdy I have yet to break one wobble is minimal in the single hilts and the are realy realy light.\

Give me a day or to to get the part numbers All in all it only cost about $15 bucks to make the pommel and emitter have to be bought

 

[Primrodo]

http://www.tapplastics.com/shop/product.ph...949031074769446

Well would be something like 4 bucks for enough for a 3' but still...

 

[Bowelrock]

Thanks Primrodo I will definatly look into them

 

[Darth Kahnt]

Thats pretty sweet.