Unlimited Run Aluminum vibro axe blade

whats the cannon connector, what did i miss?
Its this thing
20200912_134857.jpg
 
I wasn't going to do this but I liked the way it looked. I used a tamiya weathering kit and painted the yamaha piece gun metal. The blade sides are soot color. I might weather them a little more.
20201207_175139.jpg
20201207_175221.jpg
 
Just wanted to say for those that are going to use the 3m rubber insulating tape, you can paint it and clear coat it. It actually gave it a smothe finish and it strengthened it. I would highly recommend at least clear coating it.
 
Here's mine so far. I haven't had much time to work on it lately but last weekend I was finally able to start putting it together. Hopefully I'll be able to finish it up soon. I'm trying to go for the Hero version rather than the resin stunt so some of the colors and weathering are a bit different. I haven't weathered anything but the blade yet so it's still too clean and shiny.
139675192_433555944667729_8410900917355415063_n.jpg
139973946_1638455393001124_6889085834376715374_n.jpg
141371371_218711929930455_3488897573813352491_n.jpg
141418119_808767376371005_7125000152594648635_n.jpg
141435243_427176128697650_761505266357435890_n.jpg
141635288_732444827663470_2537499005398820570_n.jpg
141773589_2297108030413548_5295388625069258493_n.jpg
141921145_406689213743050_2565744581195453644_n.jpg
141922606_407520686983616_1331025265861262551_n.jpg
142046921_258073075751884_1971109453305227495_n.jpg
 
Here's mine so far. I haven't had much time to work on it lately but last weekend I was finally able to start putting it together. Hopefully I'll be able to finish it up soon. I'm trying to go for the Hero version rather than the resin stunt so some of the colors and weathering are a bit different. I haven't weathered anything but the blade yet so it's still too clean and shiny.View attachment 1414454View attachment 1414455View attachment 1414456View attachment 1414457View attachment 1414458View attachment 1414459View attachment 1414460View attachment 1414461View attachment 1414462View attachment 1414463
Are you going to put the screw detail in the yamaha piece?
20201101_180357.jpg
20201213_143621.jpg
 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top