Hey Erick yes I did,
I first had them milled down so they were thinner, and then used self tapping screws to mount them to the bottom, let me know if you need a picture of the bottom, here is a picture of the milled down Extinguisher tops, I also got a good hole saw drill bit and drilled out the center, or you could just screw the Nozzles to the flat part of the extinguisher top if it is flat enough.
I bought PVC pipe today and started the Pieces on the top, I heated and bent some 1" PVC and then filled it. I'll sand it tomorrow and if it looks good I'll do the other side.
I first had them milled down so they were thinner, and then used self tapping screws to mount them to the bottom, let me know if you need a picture of the bottom, here is a picture of the milled down Extinguisher tops, I also got a good hole saw drill bit and drilled out the center, or you could just screw the Nozzles to the flat part of the extinguisher top if it is flat enough.
I bought PVC pipe today and started the Pieces on the top, I heated and bent some 1" PVC and then filled it. I'll sand it tomorrow and if it looks good I'll do the other side.