Scratch Build SD

Muzza

Sr Member
More Guns, Guns, Guns
I am making every one a little different as you can see.

IMG_7789.jpg IMG_7790.jpg IMG_7791.jpg IMG_7792.jpg

Just another 5 to go.
 

Muzza

Sr Member
Washing the part before applying to the SD it is very important as I use a release agent on my molds so they last a little longer.

IMG_8276.jpg
a old sieve stops them going down the sink.
IMG_8277.jpg
Always add a little of soap liquid to wash your parts.
IMG_8278.jpg
Use hot water to rinse the parts and place on paper towel the hot water will help to dry them quicker.
IMG_8279.jpg IMG_8280.jpg IMG_8281.jpg IMG_8282.jpg IMG_8283.jpg
I will also add some kit parts into the mix.
 
Last edited:

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top