*New* Need some tips - building Vash Gun made by SidKit

haloboyvash

Active Member
Hello I'm new to modeling and I just got my hands on my first kit.

It's a Sidkit version of Vash the Stampede's .45 Long Colt Revolver. It has resin and metal parts and has some work to be done.

I was needing some tips on what tools/adhesives I would need for doing the prep work on this. Like clearing some extra flash, or smoothing edges with certain types of sandpaper. Anything constructive will be greatly appreciated!
 
Last edited:

Contec

Master Member
Re: *New* Need some tips for modeling

First of all is to wash the resin parts in luke warm water and some soap to get the mould release agents off.
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top