-
Welcome to the Project Runs Forum!
This forum is intended for interest gauging and active runs. Due to the transient nature of this forum, please keep all research and ongoing discussion in one of our main forums so your information is not lost.
Only Premium Members can start a new run.
Limited Run Luke Shared stunt Version Lightsaber ( Run Full )
- Thread starter Spirit of ob1
- Start date
Son of Skywalker
Well-Known Member
I just read your post about cleaning them. I can clean mine.
darthsnikelfritz
Well-Known Member
Mine arrived Friday. Everything looks flawless, i can wait to get started. Thanks
Banthapudu4788
Active Member
Squeeze the clamp together. Rotate level counter-clockwise. Clockwise to tighten. The 4 tabs that face inward into the clamp need to be ground down before installing the clamp on the saber. A small suggestion, unscrew the "grenade" section to install so you don't scratch anything sliding the clamp down the saber.
ImperialShuttle
Member
Squeezing the clamp together is key to getting the lever to rotate. Flip the lever open a little to also facilitate turning.
No 6
New Member
Thanks!
Oh, and what is the correct size D-ring for the pommel? I already mangled the one that came with it trying to grind it down to fit.
ImperialShuttle
Member
Not sure about the d-ring size. I haven't tried to use it yet because I have other work to do on the saber.
I did have some luck prying open the d-ring that came with the saber by inserting one pair of closed plyers inside the ring and using both hands to then open the plyers. This worked a lot better than using two pairs of plyers to pull on both sides of the ring, which seems to mangle it. No idea if it will fit in the hole yet though.
Edit: I just tried the d-ring. Yeah, doesn't seem to fit. I'm going to try filing it down a little. Not sure what else to try.
I did have some luck prying open the d-ring that came with the saber by inserting one pair of closed plyers inside the ring and using both hands to then open the plyers. This worked a lot better than using two pairs of plyers to pull on both sides of the ring, which seems to mangle it. No idea if it will fit in the hole yet though.
Edit: I just tried the d-ring. Yeah, doesn't seem to fit. I'm going to try filing it down a little. Not sure what else to try.
Last edited:
It seems some work and others didnt, if you can find a true 3mm it will work fine, if not a 2.5mm will work. i just ordered a 2.5mm.
ImperialShuttle
Member
Where did you order yours from?
Lightwire 1 inch
https://www.etsy.com/listing/167636459/10-pcs-metal-d-ring-38-12-58-34-1-1-14-1
let me test it before you order
- - - Updated - - -
I know Roys fit great, but i think hes out currently
https://www.etsy.com/listing/167636459/10-pcs-metal-d-ring-38-12-58-34-1-1-14-1
let me test it before you order
- - - Updated - - -
I know Roys fit great, but i think hes out currently
ImperialShuttle
Member
Thanks, i was waiting for Roy's shop to open again. I look forward to hearing how the etsy ring works out for you.
Got mine! I feel bad weathering it cause it's so crisp.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Collectorchris
Well-Known Member
I received mine yesterday and this is a thing of beauty! This one was very well worth the wait and I thank you for doing this limited run and that I could get in on it! Great Job!!!
Similar threads
