Deadline for wolverine claws help

B

BlueSteel

Guest
Hey everyone 3D printed some nice looking wolverine claws last week and have them painted and smoothed almost completely, BUT HOW DO I GET THEM TO FIT ON MY HAND!? I'm using the handle design used fpr the props in the movies where you grab the handle and the claws are connected by wire or another material, but My wire is far too bendy and when I try to hold the handle with a claw connected it doesn't look even remotely connected. Super nervous about finishing these for a friend cause he needs them Friday night any help would be great thanks.
 

Lord Magneto

Sr Member
take a metal coat hanger... bend it to the shape you need... shove it in the hole in the claws... shove the other end in the handle and bend it till you are happy with the fitting... then you can glue it in place.
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top