DarthVador
Active Member
Very nicely done Jim,you may want to light block everything before you do start on any lighting,I plan on using gray primer then use a gloss white on the inside for the light blocking then on the outside will be a couple coats of gray for the finish coat along with the red stripes..
That is what I am hoping to do with mine,I did start on mine but only washed some of the parts and remove some flash..I am stuck trying to figure how the engine box goes together I am going to have to look through this thread and cabour build to see how to put it together,I am also having issues with my new Bridge I got I can not seem to get the pre drilled holes cleaned out to run my fiber optics,they are plugged tight,I have contacted Tony and he suggested to try a couple things to me and I have had no luck.
Everything is going slowly for me on my TOS BSG but I did start it,lol
Clarence
That is what I am hoping to do with mine,I did start on mine but only washed some of the parts and remove some flash..I am stuck trying to figure how the engine box goes together I am going to have to look through this thread and cabour build to see how to put it together,I am also having issues with my new Bridge I got I can not seem to get the pre drilled holes cleaned out to run my fiber optics,they are plugged tight,I have contacted Tony and he suggested to try a couple things to me and I have had no luck.
Everything is going slowly for me on my TOS BSG but I did start it,lol
Clarence