Engineermaker
New Member
Hi Propmaster2000, thank you!
I use my Zortrax M200 filament printer and ABS+ Silver, sometimes I also use Zortrax own ABS blend UltraT.
Here's a Dalek gun I made a while back on the printer (barrel fittings are from Thingeverse, the rest are all my models).
Raw print test assembled.
This is with a thin primer and a few thin airbrushed coats of metal Air from Valejo, after fine sanding only and no filler or acetone smoothing.
I designed both the gun and the helmet parts to have insert blocks of things with different height so I can sand them smooth separately, like this:
I use my Zortrax M200 filament printer and ABS+ Silver, sometimes I also use Zortrax own ABS blend UltraT.
Here's a Dalek gun I made a while back on the printer (barrel fittings are from Thingeverse, the rest are all my models).
Raw print test assembled.
This is with a thin primer and a few thin airbrushed coats of metal Air from Valejo, after fine sanding only and no filler or acetone smoothing.
I designed both the gun and the helmet parts to have insert blocks of things with different height so I can sand them smooth separately, like this:
Last edited: