63SSRagtop
Jr Member
Got some of the wiring done and finished up the seat as far as shaping goes.. looks like the place where I put the electronics is going to be a good place.. from what I can tell the main harness will go around the right side of the frame.. Will have to extend a hot line directly to the starter relay but I should have that mounted way down low in the am behind the kick starter..
I thought there would be more harness modifications but it looks like i'll be able to either double it over under the tank or just sever the harness and put in a quick disconnect for the front end.. been looking at all kinds of connector but radio shack had some basic 9 pin male and female and also 12 pins for cheap cheap... will probably just use them and put some dielectric on the pins and some liquid electric tape in the back and heat shring the whole connector.. It'll be cleaner and will come apart very easily down the road...
Talked to a local today about covering my seat, I've done all the work besides sewing, I had a heart attack when the guy said 400 ish.. no sir.. not happening.. going to try another cat out of town tomorrow and see what he can do.. and give the in frame bag a go myself.. got some cool 'design' paper (can use butcher paper and a stapler just as easily though)
I thought there would be more harness modifications but it looks like i'll be able to either double it over under the tank or just sever the harness and put in a quick disconnect for the front end.. been looking at all kinds of connector but radio shack had some basic 9 pin male and female and also 12 pins for cheap cheap... will probably just use them and put some dielectric on the pins and some liquid electric tape in the back and heat shring the whole connector.. It'll be cleaner and will come apart very easily down the road...
Talked to a local today about covering my seat, I've done all the work besides sewing, I had a heart attack when the guy said 400 ish.. no sir.. not happening.. going to try another cat out of town tomorrow and see what he can do.. and give the in frame bag a go myself.. got some cool 'design' paper (can use butcher paper and a stapler just as easily though)