Using Foam Board for Eagle Launch Pad

Thread starter ArtooThreepio12
Start date Mar 14, 2013

ArtooThreepio12

Active Member

Mar 14, 2013

I am planning to create a mock-up of a Moonbase Alpha Launch Pad to showcase my new Product Enterprise Eagle Transporter and thought of using foam board.

However, here's my question: How do you 'hide' the joins and make a nice smooth corner? I am thinking that when I join to make a corner of a building, for example, you will be able to see the foam inside of the board unless I mask it somehow.

I am sure the architecture and other model makers encounter this all the time, but I am new to this and could use some practical advice.

This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

Your new thread title is very short, and likely is unhelpful.
Your reply is very short and likely does not add anything to the thread.
Your reply is very long and likely does not add anything to the thread.
It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
Your message is mostly quotes or spoilers.
Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
This thread is locked.