Stargate Crystal Mold

Thread starter Trinium
Start date Jun 7, 2015
Tags

stargate atlantis

Trinium

New Member

Jun 7, 2015

So I came across something on thingverse that was made to make Crystal Ice Cubes. Well I printed it out, then scaled it up I think it would be be perfect for making crystals for that 2 part resin. Plus it has a side that could easily be slid into a hole for mounting! I Mean all the crystals on SGA were molded anyways right? Plus this has the circuits built in! I am currently printing a 3rd middle size mold.... Can anyone recommend the material for doing this?

This work is attributed to

By_Ron9083 on Thingverse

This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.