Rapid Prototyping

Thread starter UKscout
Start date Feb 1, 2006

UKscout

Well-Known Member

Feb 1, 2006

hi guys

I've got my version 2 of the Scout Helmet snout part done in cad but my contact who made my first prototype has now sold is rapid prototyping 3d printer

Dose anyone here now of a good company to goto please as some of the qoutes i've had back are coming out at near to £200 :cry

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.