Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

mangoes7

New Member
Decided to take a swing at making a Kylo Ren helmet today and will be starting it all out by using pepakura! I will post WiP pics as I progress through. The file that I found wasn't completely finished but i'm confident it will still come out with great results, just may take a bit more preparation as none of the pieces are numbered.


If any one has any questions or concerns let me know! :)

Some WiP:
IMG_1657.jpg


20180212_001414.jpg

Most updated WiP on the front portion of the helmet:

20180212_202203.jpg


IMG_1657.jpg


20180212_001414.jpg


20180212_202203.jpg
 
Last edited by a moderator:

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

mangoes7

New Member
Thank you, George!

I guess I should have clarified that a bit more, but the file I am using is complete to the point that I will be able to actually finish it completely. The only thing that makes it "not completely finished" to me is that none of the pieces are actually numbered. However, it was obviously not a very big issue for me as I ended up starting it any way :D
 
Last edited by a moderator:

mangoes7

New Member
ahh there it is!!

I knew before I printed this project that getting the edge ID's on the file was something pretty simple.. I just haven't used pepakura in about 5 years so I knew I was going to be a bit rusty! I will definitely remember that when I attack my next project! :)
 
Last edited by a moderator:

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top