pep unfolding question

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


jamesthebatman

Active Member
Can someone please give me some info on how to properly do an unfold? I have a couple of 3ds models I would like to build, but they come out as gibberish. And on one sheet too. How would I get it on to multiple sheets and going properly? Thanks!
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Scandvoice

Active Member
Maybe this is a dumb question - have you bought Pepakura Designer? Because it sounds like it's the Viewer version you're working on.
 

jamesthebatman

Active Member
Doh! I think you may be right. I do indeed have both, but didn't bother to check which one the pdo is set to open by default with! Again I say doh!
 
Last edited:
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top