ChameleonOne
Active Member
Upgrading to GraflexSaber's 3d printed chassis.
Great design, but I'm going to spend hours sanding and cleaning the parts for a smooth metallic finish.
I'm not looking forward to the wiring and soldering, but maybe I'l get it cleaner than my last install, that was quite messy...
Found lots of greeblies to customize the crystal chamber. (guitar strings and watch parts are great)
Looking for a stator from a brushless dc motor, to use as a crystal holder.
Going to have to "hack" my soundboard to use a single 18650 battery. Hope that goes smooth.
Anyway, here are some WIP pictures:
Great design, but I'm going to spend hours sanding and cleaning the parts for a smooth metallic finish.
I'm not looking forward to the wiring and soldering, but maybe I'l get it cleaner than my last install, that was quite messy...
Found lots of greeblies to customize the crystal chamber. (guitar strings and watch parts are great)
Looking for a stator from a brushless dc motor, to use as a crystal holder.
Going to have to "hack" my soundboard to use a single 18650 battery. Hope that goes smooth.
Anyway, here are some WIP pictures: