Modding a MR FX Obi Wan saber

Solo

Solo

Sr Member
Guys and gals is it possible to modify a MR FX Obi Wan saber with a thin neck? Are there any tutorials and kits out there for people who are not master prop builders? :confused

Thanks for the help!
 
Ive seen it done once. You have to cut the entire neck section off, machine an entirely new neck. If you don't want a removable neck, you can just lengthen the wires that connect the LED string to the sound board.
 
If i was going to attempt this I would start on thecustomsabershop.com forums.

if you can do it, that will be the best place to look and ask for info.
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top