Jonathan Bowen
New Member
So I'm working on a set of Mara Jade kits. Mostly laser cut stuff. I have a bit of a question on the harness.
This is what I have so far.
Its laser cut MDF so it has an actual slot for the leather. Should be a bit more comfy then most of the ones I've seen out there.
The big question is does the center piece need to be taller? Most of the builds I have seen have it much taller. However, this is the only reference shot I have found so far and it looks very flat.
Just wondering if there is some reason that most everyone does it with a taller center bit. I can add another layer of MDF to the kit.
I've also done a holdout blaster for the costume. It's an MDF kit as well but I'll do another build log for it once I start the second round of prototyping with it. I have a few bits to figure out first.
I'm looking to develop a few other kits like the cape clasp and maybe a belt kit. Also looking at Green Dress Mara for a few bits.
This is what I have so far.
Its laser cut MDF so it has an actual slot for the leather. Should be a bit more comfy then most of the ones I've seen out there.
The big question is does the center piece need to be taller? Most of the builds I have seen have it much taller. However, this is the only reference shot I have found so far and it looks very flat.
Just wondering if there is some reason that most everyone does it with a taller center bit. I can add another layer of MDF to the kit.
I've also done a holdout blaster for the costume. It's an MDF kit as well but I'll do another build log for it once I start the second round of prototyping with it. I have a few bits to figure out first.
I'm looking to develop a few other kits like the cape clasp and maybe a belt kit. Also looking at Green Dress Mara for a few bits.