Interest Luke v2 Lightsaber. Unibody design

[teecrooz]

Dan, not to hijack too much, but is there a chance you will model up the stunt version and offer that in the future also?

 

[newmagrathea]

I have one off the last run and it's gorgeous. It kind of broke my heart to bang it up to weather it. I'm just curious how you would get a clamp on if it's all one piece.

 

[Nukerz]

2 question,? Will it have uneven rings? Do you think clamp will be damage by spreading so much? Id like more 3 pieces body, more accurate, easy clamp installation and ... Yea more accurate xD,
But if there is way not to risk to damage the clamp, id be interested

 

[Luuke]

DAMN YOU ANDREW!!!! Why I otta... why if I could finish a sentence I'd...

 

[monkeydeeznutz]

Interested! Is there any chance for a 3 piece body?

 

[Conranc]

Count me in

 

[Rachen]

Defiantly in sign me up good sir

 

[DickStompington]

Any chance of you doing another run of the 3 piece with the spinning emitter? I wouldn't mind paying the extra $40

 

[SethS]

I have one off the last run and it's gorgeous. It kind of broke my heart to bang it up to weather it. I'm just curious how you would get a clamp on if it's all one piece.

If you unscrew the pin all the way (which you'd have to do to replace it with the long V2 lever) Graflex clamps actually open up quite a bit-- easily enough to slap on the saber. You'll just have to file down the interior tabs.

 

[MacBeath]

Please sign me up!

 

[Pedro]

I'd probably be interested but as a few have said would likely prefer the multi piece design (missed the other run!).

 

[GeoffMartin3299]

def interested. sign me up

 

[jcru]

Any chance of you doing another run of the 3 piece with the spinning emitter? I wouldn't mind paying the extra $40

Same here.

 

[juajn7fernandez]

I'm in for two

 

[juajn7fernandez]

I'm in for two either way. However I wanted to know if there is any way we can get the mystery chunk drilled?

 

[JetSetWilly]

3 for me please

 

[Anakin Starkiller]

Considering getting in on this also. One quick question though, how would you be able to get the clamp on?

SInce the v2 lever doesn't slot into the sidebar like an actual graflex clamp, you should be able to fit the clamp over the pommel and then clamp it down after it's installed.

- - - Updated - - -

Dan, not to hijack too much, but is there a chance you will model up the stunt version and offer that in the future also?

Yes, I've already modeled that. I'm waiting on a prototype to be cast. After that, I'll be offering cast blanks

 

[Jack]

I'm interested in the Shared stunt version also.

 

[Padawan311]

I am definitely interested in one!

 

[Nukerz]

After many considerations about the clamp and the 3 pieces body, i say i would prefer unibody design, can we know aproximate time needed if the run will start? Thank you