takaaaa
Active Member
Im having some problems, idk if its been talked about but 52 pages is a lot to look through.
So Im not using this for Iron Man faceplate, but just to power one servo. I followed the guide and skipped over the LED eyes.
My Arduino Uno came with a 9v connector, so I used a 9v batters.
I did everything and uploaded the codes. The serve moves about 90degrees and stops Nothing happenes when I press the button. When I remove and plug the button back in, the servo moves again and stops.
One thing that worries me is that my 10ohm resistor is crazy hot. Like burnt my finger. So I quickly removed the battery and unpluged the USB.
So Im not using this for Iron Man faceplate, but just to power one servo. I followed the guide and skipped over the LED eyes.
My Arduino Uno came with a 9v connector, so I used a 9v batters.
I did everything and uploaded the codes. The serve moves about 90degrees and stops Nothing happenes when I press the button. When I remove and plug the button back in, the servo moves again and stops.
One thing that worries me is that my 10ohm resistor is crazy hot. Like burnt my finger. So I quickly removed the battery and unpluged the USB.