Check your rulers/straightedges

Thread starter Sluis Van Shipyards
Start date Oct 28, 2010

Sluis Van Shipyards

Legendary Member

RPF PREMIUM MEMBER

Oct 28, 2010

I was cutting a piece of styrene and following my pencil marks. After I cut I noticed I was cutting into the line instead of around it. It checked out my stainless steel ruler and found it had a very slight groove worn into it from using it as a straightedge. So make sure you check yours!

This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.