Here's a tutorial on how to light up your straps on your Markpoon nike air mags:love.
I went with an A5 cuttable blue/green el sheet.What i did was i took the nike decal and put it up against a piece of hard stock paper and traced an outline of it so i can make my cut out on the strap[/I] :
ic below::
then what i did was take the xacto knife and cut that shape out on my strap now there's 2 layers on the strap just carefully cut the front side of and just peel it should come right off just make sure you don't cut the bottom leather piece cause that's what you will krazy glue the el light piece strip on.Now basically with my shape cut out, I used it to determine the width of my el strip so it would fit right into the strap,:
ic Below::
now what you have to do is once you make the cut out on your strap you slice down the left side and right side of the strap with your knife so the el strip can slide through as seen below. ::NOTE:: I covered the remaining el strip with black electrical tape so it would cover any access light coming from the strip.
I went to this website for my stuff they have pretty good prices considering.
Electro Luminescence Inc
Here is the correct el sheet
Electro Luminescence Inc
and you will need 2 Inverters for small sheet/tape with alligator clips (One for each shoe)
Electro Luminescence Inc
Here's Mine takes 4 AAA Batteries and has an on/off switch on the side of inverter........
Well that should do it as i hope this comes in handy for some people :thumbsup