cavx
Master Member
I watched the 2015 future sequence again tonight and his jacket bends and flexes even more than my material. So I am sure that layer was just one coat of rubber now.
Also looking at my three pieces sitting on the bench and the one thing I wish I had done different was making them as 3 separate parts. I will no doubt me making more of this material, so will modify the molds so that the whole vest part is made as a single piece joined at the shoulders.
By making the part as a single part, there is no need to join later at the shoulders where all of the load bearing will occur.
For mine, I intend to lay a section of cloth and add more rubber and that will be strong. This just gives it strength at a whole new level with far less weight. The seam would only be there in texture.
Also looking at my three pieces sitting on the bench and the one thing I wish I had done different was making them as 3 separate parts. I will no doubt me making more of this material, so will modify the molds so that the whole vest part is made as a single piece joined at the shoulders.
By making the part as a single part, there is no need to join later at the shoulders where all of the load bearing will occur.
For mine, I intend to lay a section of cloth and add more rubber and that will be strong. This just gives it strength at a whole new level with far less weight. The seam would only be there in texture.