Avatar Creatures size in 1/6th scale

Mostly Fantasy

Well-Known Member
Hey all- I'm looking for a bit of help with scale. I've found the sizes listed of 3 of the creatures from "Avatar", but can't get a good view of their heads. Basically, I'm making 1/6th scale skulls for the Banshee, Leonopteryx, and Thanator, and need to know how long their heads are. The only comparison chart I've found is way to small to make good measurements from.
Thanks for any help!
I'm sure there is probably something out there or someone will have something but if not, the scaling on the figures seems pretty accurate.
I would assume that one could compare and do the math to up-scale the heads.
(Thats how I would do it.)
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.