JDVaughan17
Active Member
What’s up guys, I’m back, I’m making my second 7 piece spidey suit. Let’s get right into it.
So the base suit was purchased from ZentaiZone. It used their red and deep blue fabrics.
The first thing I did was attach some snaps around the waist. I got these snaps from Walmart. I ended up using 5 of the big ones, and 4 small ones around the waist.
The next step was to start drawing on the webs. I used a washable crayola marker, so that way I can get rid of any mistakes.
For the mask, I threw it on my Tjack face shell and just kinda free-handed it. For the body, I put it on a pillow and used a ruler to measure out all the webs. For the boots, I put a roll of paper towels in them and measured them out. I based the web pattern off the Homecoming and FFH suits.
The front spider I originally had was 3D printed, but it was too stiff. So I ended up tracing it onto a piece of fabric stabilizer and plastidipped it. The back spider is the same fabric stabilizer, wrapped in red fabric.
The next step is painting the webs. I mixed puff paint with liquid latex, so that they would be more durable. Then I went to town on the suit.
I still need to do the webs on the gloves, and install Kung-fu shoes into the boots. I’ll try to keep this updated, but if i forget, I’ll post everything on my Instagram @vaughanilla_ice
So the base suit was purchased from ZentaiZone. It used their red and deep blue fabrics.
The first thing I did was attach some snaps around the waist. I got these snaps from Walmart. I ended up using 5 of the big ones, and 4 small ones around the waist.
The next step was to start drawing on the webs. I used a washable crayola marker, so that way I can get rid of any mistakes.
For the mask, I threw it on my Tjack face shell and just kinda free-handed it. For the body, I put it on a pillow and used a ruler to measure out all the webs. For the boots, I put a roll of paper towels in them and measured them out. I based the web pattern off the Homecoming and FFH suits.
The front spider I originally had was 3D printed, but it was too stiff. So I ended up tracing it onto a piece of fabric stabilizer and plastidipped it. The back spider is the same fabric stabilizer, wrapped in red fabric.
The next step is painting the webs. I mixed puff paint with liquid latex, so that they would be more durable. Then I went to town on the suit.
I still need to do the webs on the gloves, and install Kung-fu shoes into the boots. I’ll try to keep this updated, but if i forget, I’ll post everything on my Instagram @vaughanilla_ice
