clanleader16
New Member
Hi All!
Just getting started on my shield build! I started with a 26" Flexible Flyer saucer sled, and am starting to make some progress. Got the powder coat stripped off of the front, and working on the back now. The front has also been sanded, starting with 120 grit, and worked my way incrementally to a 320 grit sand paper. Next steps are to finish strippping and sanding the back of the sled, and then measure and cut the sled to size. I'm a bit concerned about warping the edges when I cut the sled, so any tips to prevent this would be greatly appreciated. Thanks!
Just getting started on my shield build! I started with a 26" Flexible Flyer saucer sled, and am starting to make some progress. Got the powder coat stripped off of the front, and working on the back now. The front has also been sanded, starting with 120 grit, and worked my way incrementally to a 320 grit sand paper. Next steps are to finish strippping and sanding the back of the sled, and then measure and cut the sled to size. I'm a bit concerned about warping the edges when I cut the sled, so any tips to prevent this would be greatly appreciated. Thanks!