How have I not seen this thread until just now?
I want to make rails and upper copper part from brass.
No matter what material was used in WG/CU sabers, more important is how it looks. And it looks much more like oxidized brass.
luke originally to use the green lightsaber in the crait showdown
luke originally to use the green lightsaber in the crait showdown
[
Hi. Yes, it will be made for electronics install. Heatsink will be 20mm diameter for tri-cree with lens, emitter will be 25.47mm diameter with 26mm depth for blade install.@lukyanov is your saber to be an FX saber? If so what is heatsink solution, what diameter blade is going to use?
Hi. Yes, it will be made for electronics install. Heatsink will be 20mm diameter for tri-cree with lens, emitter will be 25.47mm diameter with 26mm depth for blade install.
View attachment 804924 View attachment 804925
I'll start it next week.Is there a run thread? Otherwise this is hard to follow.
I'll start it next week.
I can understand having Luke look like he did the last time Kylo saw him, but I think the green saber would have made more sense. That is what Luke had when Kylo knew him and the blue saber is more associated with Anakin than Vader. Having Luke use Vader's saber would have really messed with Kylo but confuse the audience.
The lack of Luke disturbing the lighter ground material was enough clue for the audience that he was a projection.
Sent from my SAMSUNG-SM-G930A using Tapatalk
Yes, distracting Kylo appears to have been the point of Luke's choices in appearance. I forgot that Kylo was pursuing the Graflex. Vader seemed to reject anything associated with Anakin. I would have thought Kylo would too since he would view Anakin as weak compared to Vader.Perhaps he was using the Graflex to wind Kylo up....Kylo was after that Lightsaber after all and in TFA said that it belongs to him. Seeing Luke with it would surely anger him knowing that he had failed in obtaining it and distract him from the Resistance trying to escape Crait.
I'm in for one...If you do the run.I'll start it next week.
@halliwax just to let you know that Slothfurnace is now looking at a double sided 10 trace/13 trace card which is slightly longer so either side can be trimmed as required