renegadecow
Active Member
Plain 2 part epoxy would work. First make sure all edges are degreased and lightly roughened with sandpaper. Slop on some on the mag edges first then clean it up with a file when cured. When that's done, apply scotch/cellophane tape around the mag as a mold release plus the added thickness makes sure the mag won't bind from sheer tightness. Goop on epoxy around the magwell then insert the magazine. While the epoxy is set but not yet full cure, carefully trim off the excess flash that may make it harder to separate the magazine. When cured pop out the mag, remove the tape and clean the edges up a bit with fine sandpaper.Can anyone recommend a method for building up the plastic around the edges of the mag? I plan on using magnets to hold it in place but would like structured sides.