Imagehunter
New Member
Resin printing my PKD grips. I need advice on colour. I have orange and red translucent resin and was thinking of mixing them to get the right colour. Any thoughts on ratios to get close?
PKD grips
- Thread starter Imagehunter
- Start date
There’s an amber resin that comes out pretty nice.
The name escapes me, I’ll post it when I get home.
I used it to make mine and they turned out pretty nice I think. If you’re using the Anders model I may have a spare set I’d be willing to part with
Edit: found it
SuperFast 1000g Amber Water Washable Resin, 0.7 Sec (Mono 50um), 3.0 Sec (LCD 50um), Made in Korea Amazon.com
Quick disclaimer: I sanded up to 2000 grit and used a polishing wheel to get them super clean and translucent
The name escapes me, I’ll post it when I get home.
I used it to make mine and they turned out pretty nice I think. If you’re using the Anders model I may have a spare set I’d be willing to part with
Edit: found it
SuperFast 1000g Amber Water Washable Resin, 0.7 Sec (Mono 50um), 3.0 Sec (LCD 50um), Made in Korea Amazon.com
Quick disclaimer: I sanded up to 2000 grit and used a polishing wheel to get them super clean and translucent
Attachments
Last edited:
Imagehunter
New Member
Those are gorgeous. I do want to try mine though so I can print extras. I could experiment with the colour but I'd rather not waste any resin. Thanks anyway.
