cavx
Master Member
Because my Heel Cup is now larger than all other V2 cups, I needed to re-do my letters. The first 2 sets were basically cast off the V2 Heel Cup and so they were essentially the same size. My mold seemed to suggest that they were larger when laid out flat but as soon they were glued to the shoes, they were back to the original size.
So I made myself a new template from this one and modified it in SketchUp.
It now looks like this.
I then mixed and poured (after vacuuming of course) white and aqua rubber over the respective parts, and tonight, cut them out and attached them to the shoes.
Here is my shoe a few days ago (top) and tonight (bottom). The tape has since been removed.
Does anyone want to comment on the colours? This is my chart that I have been basing my shoes on.
So I made myself a new template from this one and modified it in SketchUp.
It now looks like this.
I then mixed and poured (after vacuuming of course) white and aqua rubber over the respective parts, and tonight, cut them out and attached them to the shoes.
Here is my shoe a few days ago (top) and tonight (bottom). The tape has since been removed.
Does anyone want to comment on the colours? This is my chart that I have been basing my shoes on.