ichnob
Well-Known Member
Done!
I actually finished the build yesterday, but kept running into errors. Since I'm not using the Darth Ryo chassis, my recharge port wires kept getting snagged on the grip pegs inside. So I kept getting instances where it would work, then doing something later would not work. Like adding the kill key was fine, but then removing the bottom would cause the kill key to get caught and break the wires. Or thinking that the wire channel I dremeled was deep enough for the recharge port wires (it wasn't...even after the 2nd time I dremeled deeper). All in all, great learning experience in making my first saber. Can't wait to work on my next few in the future.
I actually finished the build yesterday, but kept running into errors. Since I'm not using the Darth Ryo chassis, my recharge port wires kept getting snagged on the grip pegs inside. So I kept getting instances where it would work, then doing something later would not work. Like adding the kill key was fine, but then removing the bottom would cause the kill key to get caught and break the wires. Or thinking that the wire channel I dremeled was deep enough for the recharge port wires (it wasn't...even after the 2nd time I dremeled deeper). All in all, great learning experience in making my first saber. Can't wait to work on my next few in the future.