Finished modelling Syd Mead's concept blaster and decided to do a run of them. Want to buy a decent 3d printer so I can make the master before resin casting the kit. Before buying one, I want to make sure the interest is there. Looking for 10 people who would be up for buying a kit before investing in a printer. Estimating the kit will cost about £90/$150 + P&P from the UK.


It'll be a multi-piece kit, allowing the barrel to hinged from the main body of the gun, a hollow body to allow electronics to be fitted and a hollow power cell that should fit a CR123 that will fit in the rear hatch and power the electronics.
Not looking for any money down, won't be taking any money until I have finished and ready to ship kits. If you're interested, drop me a PM.
Original thread: http://www.therpf.com/f9/syd-meads-concept-blade-runner-blaster-221377/
Interest List
1. sean
2. Nidgit
3. TheRocketeer
4. Riftmaster
5. bothanspy
6. Beastmaster
7. 3oin
8. Hirohawa
9. Bad Wolf
10. asavage
Reserve/second run list
1. silverskyes402
2. Andy3E
3. Jbar
4. Belmekor


It'll be a multi-piece kit, allowing the barrel to hinged from the main body of the gun, a hollow body to allow electronics to be fitted and a hollow power cell that should fit a CR123 that will fit in the rear hatch and power the electronics.
Not looking for any money down, won't be taking any money until I have finished and ready to ship kits. If you're interested, drop me a PM.
Original thread: http://www.therpf.com/f9/syd-meads-concept-blade-runner-blaster-221377/
Interest List
1. sean
2. Nidgit
3. TheRocketeer
4. Riftmaster
5. bothanspy
6. Beastmaster
7. 3oin
8. Hirohawa
9. Bad Wolf
10. asavage
Reserve/second run list
1. silverskyes402
2. Andy3E
3. Jbar
4. Belmekor
Last edited by a moderator: