Sinktube Vader lightsaber template?

[mtsbspidey]

I've had a bunch of Vader lightsaber parts sitting around for a while now. I'm finally getting around to throwing them onto a sink tube. Unfortunately I can't seem to find a template for the MPP holes. Can anyone help me out?

 

[Sym-Cha]

Perhaps Roy's MPP DV ESB Blueprint will give you some ideas : http://wannawanga.com/wp-content/uploads/2015/10/blueprint-DV-ESB.jpg

Chaim

 

[Darth Lars]

There is also Darth Saber's old blueprint. It has the sizes for the holes.

 

[matty matt]

I've used this one before.



- - - Updated - - -

I've used this one before.

 

[Probe Droid]

I don't know if these are helpful, but here's the real deal.














I've got multiple MPP ref pix in a Flickr album. Good luck with your build.

 

[mtsbspidey]

That is all going to be so helpful. Thank you guys so much.

 

[thd9791]

I would try drilling two holes next to each other and using small needle files to remove the rest, clean up the sides. You'll get more of what you wan that way, rather than cutting a rectangle and trying to round out the corners

 

[matty matt]

I would try drilling two holes next to each other and using small needle files to remove the rest, clean up the sides. You'll get more of what you wan that way, rather than cutting a rectangle and trying to round out the corners

That's exactly how I did this one a few years ago. :thumbsup