Scout Trooper - Children’s Costume

Lohner

New Member
I wanted to share the Halloween costume I made for my 10 yr old.

First off I want to point out two things.

1) I realize that is not the proper weapon
2) completely upset with myself that I didn’t notice I had the cummerbund inside out. (I had weathered the other side)

I found the armor and helm on thingiverse. I used Armorsmith to scale the files to the proper size and then printed out. After lot’s of sanding I was off to make molds.

I had never made molds before. I made a few expensive mistakes but, was really getting the hang of it towards the end. Working on my Mandalorian costume now and plan on making castings of the printed pieces.

Anyway just wanted to share with the group. Although I see many mistakes I’m still happy with the results. Especially since trick-or-treating was cut so short this year.




81044313-96A5-4B7D-A3AA-0E6013AB3958.jpeg
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top