Limited Run RUN CLOSED * DL-44 ESB Blaster Machined Parts Set * RUN CLOSED

[2keepandbear]

Once again... LOVE IT

 

[LB66679]

Ooooooooh ! So excited !

 

[masterjedi322]

Perdy!

Can't wait!

Sean

 

[diggidog]

That looks killer! Trying to hold back the excitement and be an adult about this, but I can't freakin' wait to put my Bespin Han blaster together!!

 

[Solos blaster]

I can't remember if I got this new scope bracket or not to update my old one, but I feel like I should've hahaha.

Great work, the anticipation is building!

 

[matty matt]

Lookin' good! You guys are going to have really nice blasters.

 

[Boba Debt]

I was going to set up a Hoth Bracket test subject but the hardware is tougher to pin down then I expected

I found 3 sizes that are possible

2 Standard sizes #4 & #6 and a metric size M3

In my opinion I think it is an M3 because the #6 looks too large but the allen socket in the #4 looks too small. The M3 has the smaller head with the bigger allen socket hole so I think that’s the best option for this bracket

There is a #5 bolt but they are very rare and I have to special order them so I doubt that would have been used.


Please post your opinion below

 

[LB66679]

m3 looks most correct to me personally

 

[Jedifather]

I like how the #4 doesn't hang over the outside edge of the ring.

 

[newmagrathea]

I think M3 looks the best, #6 looks ok, #4 looks too small to me.

 

[OdiWan72]

M3 seems to be the best solution!

 

[Taco-Bot]

I'm probably about 95% confident that the M3 is right. The #4 looks closer than the #6.

 

[thd9791]

The holes in both my real thorens discs are not on point so the real screws may hang over the inside edge a bit.

They shouldn't hang over the outside edge at all though. Do the M3s?
I'm voting for the M3s too, as long as the only hang over the inside edge

 

[scottjua]

I'm thinking #4 too... but I'm torn.

Are those tests on a real disc or the replica?

 

[thd9791]

if this helps?

 

[kurtyboy]

I must say it's a very very close call. I can't decide for the life of me and at this blurry resolution it's near impossible to measure accurately.

- - - Updated - - -

This blaster was built in the USA though wasn't it? USA = #4, UK = M3.

 

[matty matt]

We have metric bolts over here. They are not uncommon. I think the M3 look the best either way.

 

[Boba Debt]

I'm pretty sure it as the M3

In the photo the center allen socket on the #4 looks a lot bigger then in person.

When I just look at the bolts in person the M3 looks like it is the most correct.

 

[3oin]

I must say it's a very very close call. I can't decide for the life of me and at this blurry resolution it's near impossible to measure accurately.

http://i678.photobucket.com/albums/vv142/kurtyboy2/props2/buttonheads.jpg

- - - Updated - - -

This blaster was built in the USA though wasn't it? USA = #4, UK = M3.

Great comparison pictures.

For me, 2 out of 3 of the M3's look correct in the images, so I'm blaming the lighting for making that top M3's socket look a bit big, the lower two look very accurate.

M3 for me.

 

[BrooklynGuy]

I like the M3 as well