Pressure Pot Compressor

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


Jive Turkey

Member
I've been looking into getting a pressure pot for resin casting. Was wondering if my airbrush compressor would be powerful enough to use. The compressor has a max psi around 57, but I'm not sure if that translates to pressurizing an external pot. Do I need to get a second compressor?
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Jkirkon

Sr Member
Yeah, I doubt that compressor would have enough volume to do the job adequately.

I use a Porter Cable 3 gallon (I think) pancake air compressor. It is adequate for the small pressure pot that I have.
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top