Chaank
Sr Member
Hey folks, I've been working on an art project and it's going to take a lot of scratch building using styrene, model kit parts and some hacked up toys. I'm making patterns using standard printer paper and sticking it to the styrene sheet for cutting out which is working great but I'm having trouble removing the paper and glue afterwards for a clean finish. I've been using a spray contact adhesive to stick the patterns on and iso to remove it after they're cut. It's ok but far from clean and quite time consuming. Do any of you good folk have any tips or a better method to this issue? I've been looking round the web, ytube and the forum and haven't found much so far. I'm sure someone must have mentioned this in a thread somewhere but...
Any help greatly appreciated
Any help greatly appreciated