Double H
Sr Member
Hey there guys and gals,
Damn sculpting is addictive, if it were a drug I would be high as a kite. I have just finished off one project and before I have even finished casting it I have decided to start another - a P1 open-mouth.
Always wanted to do one of these, been in the pipe line for a while but just never got my ass in to gear and started it. I chose the open-mouth over the closed because in my opinion the open mouth has a much more sadistic and evil feel/look about it.
Not sure if a bio will fit over it, but can't say am fussed if it doesn't. I plan on making this sculpt a 1:1 scale (in your face size http://www.thehunterslair.com/public/style_emoticons/#EMO_DIR#/tongue.png ) to give a full scale rather than make it smaller to fit under a bio. In my opinion, an open-mouth pred should not have a bio covering it - whats the point in that? but everyone to there own lol
So.............. clay slung has began at 0900 hours this morning, so looking forward to this. I will be working on this as time comes available until my work bench and time clears then can hammer on with it. This is what I have got so far ....
Damn sculpting is addictive, if it were a drug I would be high as a kite. I have just finished off one project and before I have even finished casting it I have decided to start another - a P1 open-mouth.
Always wanted to do one of these, been in the pipe line for a while but just never got my ass in to gear and started it. I chose the open-mouth over the closed because in my opinion the open mouth has a much more sadistic and evil feel/look about it.
Not sure if a bio will fit over it, but can't say am fussed if it doesn't. I plan on making this sculpt a 1:1 scale (in your face size http://www.thehunterslair.com/public/style_emoticons/#EMO_DIR#/tongue.png ) to give a full scale rather than make it smaller to fit under a bio. In my opinion, an open-mouth pred should not have a bio covering it - whats the point in that? but everyone to there own lol
So.............. clay slung has began at 0900 hours this morning, so looking forward to this. I will be working on this as time comes available until my work bench and time clears then can hammer on with it. This is what I have got so far ....