Here is a step by step to do the LED's
Step1:
Use a hairdryer to heat up the area around the ankle bubble and then using a flat edged tool (butter knife will work), ease the edges up/off the fabric.
Do this until the entire ankle bubble lights are exposed. Then remove the lights/panel
Step 2
Buy a sheet of 1/16th styrene (if you need to ask what styrene is, you shouldn't be doing this)
Measure the old LED circuit board and cut out a new one.
Step 3
measure the LED distance and placement on your new panel
then drill the correct hole placement and have your LED's ready
Step 4
Solder your LED's together with the possitive (the longer "leg" of the LED) soldered to the next LED's negative "leg" and so forth.
Step 5
Solder the correct resistors to each possitive lead and tie in all 3 of the negative leads together.
A comparison
Step 6
cut a small slit in the back of the heel, under the ankle piece and run positive and negavite wires through, soldering them to the new LED panel
Here is how to install the JUDCO switch in the collar
Step 1
Using an Xacto knife, "pop" the seam to the top puffy part and the bottom part near the grey fabric
Step 2
Using a flat head screwdriver, work a tunnel up to the puffy part and (being VERY CARFEUL) work the tunnel up to the top of the collar
Step 3
Place the switch into the tunnel and push it up and into the puffy area (you can CAREFULLY use the screwdriver here too)
Step 5
cut a small slit in the grey fabric that is under the white leather, make a tunnel down to the midsole (same technique with the screwdriver) and push the wires down into the fabric. You may have to solder more wire to extend these wires down to the sole.
Step 6
Glue the leather back down using fabric glue