cavx
Master Member
Anyway, I decided to re-work an older prototype from this
to this
So what I have done is:
1. lowered the outward angle part to give more height to the loop over the pull hole.
2. straightened the line on the base of the collar. I don't really want to recess that back in any more.
3. reshaped the top profile. This is based on recommendations by cloneprops. The hard part about this is that when working off 2D images of the shoes, you lose that depth perception, so it becomes difficult to guage to wide the shoe will or needs to be. The longer sweep is to allow the width when my foot is in the shoe.
I think this looks slightly better than the current project with the extended collar. The problem here is that once I add a liner and fold, I lose some length.

to this
So what I have done is:
1. lowered the outward angle part to give more height to the loop over the pull hole.
2. straightened the line on the base of the collar. I don't really want to recess that back in any more.
3. reshaped the top profile. This is based on recommendations by cloneprops. The hard part about this is that when working off 2D images of the shoes, you lose that depth perception, so it becomes difficult to guage to wide the shoe will or needs to be. The longer sweep is to allow the width when my foot is in the shoe.
I think this looks slightly better than the current project with the extended collar. The problem here is that once I add a liner and fold, I lose some length.