Looks stellar! I wanted to ask, of it got slipped over, if the nipple was the same part as the emitter?
According to Brandon, the emitter is one piece on the original. On my new run, I plan to make it two pieces to allow for a light up blade option
Looks stellar! I wanted to ask, of it got slipped over, if the nipple was the same part as the emitter?
According to Brandon, the emitter is one piece on the original. On my new run, I plan to make it two pieces to allow for a light up blade option
Looks stellar! I wanted to ask, of it got slipped over, if the nipple was the same part as the emitter?
Thanks Dan! I think I'm just super confused as to what that extra set screw is for, and used the shared stunt as an explanation, seeing as it's nipple fell out :lol
Are you talking about specifically the smallest center part within the emitter? The center portion is a piece of cut rod. Easy to see in a lot of photos. Dan might be talking about the part around it (with the hole in it) which is one piece.
View attachment 775441
Might just be duplicate screws to hold the center rod.
The emitter face/flare looks a bit thick to me, but not by much, even as dented and warped as it is on the prop. It looks maybe a just a mm thicker on the upright overlay.
Depending on how many people were interested, I could probably do emitters for $30-$40
This is actually one fitted to a unibody. Which wasn't that hard. It could be done with a power drill and a hack saw. And it actually rotates too
Might just be duplicate screws to hold the center rod.
They weren’t blurred yesterday, and they were different that the TT stencils.