Needing input/advice on Batman cowl development

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


weaponx82

Well-Known Member
RPF PREMIUM MEMBER
I'm intending to make a cowl loosely based off this design.

mr-batman.jpg


Meaning, I'm intending to do a 2 piece helmet and collar style cowl for comfort and flexibility.

I'm not sure if I want the final pieces to be made out of silicone, urethane rubber or something else. Whatever I decide on to use as the final material will impact how I go about creating the molds and what not.

Has anyone had any luck on slush casting/brushing in silicone in a mold and not using a core?

Any ideas or input?
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top